Nothing more on what to do in case of leak. Slide spout over copper pipe until back of spout is flush with wall. Reinstalling the spout to check for improvement. Re-install and test the bathtub / shower faucet. Instructions on back of spout packaging are this simpleĢ. Flush out the tub spout with water and open and close the diverter valve, breaking free the middle deposits inside. It is a little bit bent on the bottom and flattened a little from being screwed against with a set screw by the looks of it. the copper pipe out of wall isn't leaking, I have plugged it to check. all components look to be in good shape with the new spout, including o rings. If the leak is very slow, you may not be able to differentiate between a hot or cold leak. If the water is cold, the leak is on the right side. If the water is hot or warm, the leak is isolated with the hot faucet. The back of the package says 1 and 1/2 inches to 2 and 7/8 inches will work for this spout. 1.With your hand, feel the leaking water. The pipe that sticks out of my wall is 1 and 7/8 inches. "Moen 7" slip fit diverter tub spout m1491" I've tried going to Google for an answer with no luck. Here are the steps for how to do it and these steps apply to most kinds. Step 4: Use vinegar and a soft brush to clean any debris off the copper piping on the bathroom wall. Step 3: Bring your new spout home and read the instructions. Step 2: Take it to the hardware store and buy a suitable replacement. But I have no clue how to fix this issue. The most common reason for a leaky faucet is an old washer that needs to be replaced. Step 1: Shut off your water supply and remove your spout from the wall. What could possibly be going wrong? Clearly the copper pipe isn't sealing inside the new spout. And when I pull the water diverter it REALLY starts to leak out the back. Only problem is when I turn my tub on, I get a bunch of water that spits out of the spout where it meets the wall. I have watched numerous youtube videos and I seem to be doing everything they are doing, simply sliding the new spout onto the copper pipe and screwing in the screw under neath the spout. So the spout that originally came with the tub wasn't long enough so the water would pour into the back of the tub and spill onto the floor, so I bought a new longer spout. It is sometimes mistaken for a cartridge leak. The symptom is generally found in new installations of 1, 2 or 3 handle tub/shower systems. Hey everyone, new go the forum, I just purchased my first house, I'm new to fixing things and I really have no one to turn to for help. When the system is turned on you'll notice a steady stream of water coming out of the showerhead while the tub is filling below.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |